Warning message

Member access has been temporarily disabled. Please try again later.
The CPEX-AW website is undergoing a major upgrade that began Friday, October 11th at 5:00 PM PDT. The new upgraded site will be available no later than Monday, October 21st. Until that time, the current site will be visible but logins are disabled.

High-Sensitivity Fast-Response CO2 Analyzer (Harvard CO2)

Status

Status: 
Operational
Operated By: 
PI
Replaced By: 

The high-sensitivity fast response CO2 instrument measures CO2 concentrations in situ using the light source, gas cells, and solid-state detector from a modified nondispersive infrared CO2 analyzer (Li-Cor, Inc., Lincoln, NE). These components are stabilized along the detection axis, vibrationally isolated, and housed in a temperature-controlled pressure vessel. Sample air enters a rear-facing inlet, is preconditioned using a Nafion drier (to remove water vapor), then is compressed by a Teflon diaphragm pump. A second water trap, using dry ice, reduces the sample air dewpoint to less than 70C prior to detection. The CO2 mixing ratio of air flowing through the sample gas cell is determined by measuring absorption at 4.26 microns relative to a reference gas of known concentration. In-flight calibrations are performed by replacing the air sample with reference gas every 10 minutes, with a low-span and a high-span gas every 20 minutes, and with a long-term primary standard every 2 hours. The long-term standard is used sparingly and serves as a check of the flight-to-flight accuracy and precision of the measurements, augmented by ground-based calibrations before and after flights.

Instrument Type: 
Measurements: 
Aircraft: 
Recent Missions: 
ASHOE/MAESA (ER-2 - AFRC); STRAT (Balloon, ER-2 - AFRC); TC4 (WB-57 - JSC); CR-AVE (WB-57 - JSC); CRYSTAL FACE (WB-57 - JSC); SOLVE (ER-2 - AFRC, Balloon)
Complete mission list:
Point(s) of Contact: